Crown CDi 2|1200 Power Amplifier - Crown

Crown CDi 2|1200 Power Amplifier

roll over the image to zoom in


Crown CDi 2|1200 Power Amplifier

SKU: CRO0345
Crown

 DriveCore Series is an evolution in amplification, providing an impressive mix of high-performance; rich feature set, and competitive cost. Using technology derived from our flagship Installed Sound amplifier (Crown DriveCore Install series), the CDi DriveCore 2|1200 offers streamlined functionality to work in almost any large-sized installation such as cinema, houses of worship, hotels, cruise lines, and more. Designed for ease-of-use in a variety of applications, the 2|1200 is a 2-channel amp that includes network control/monitoring, high-level DSP, front-panel interface, and support for driving up to 100Vrms speaker loads without requiring a transformer. The entire CDi DriveCore line comes pre-loaded with JBL speaker tunings to help make installations quicker and easier.

BLU linkNo
Channels2
Sensitivity (for full rated power at 8 ohms)0.7V RMS
Rated Power Output (per channel @ 4 ohms)1200W
Analog Input Signal to Noise Ratio (ref. rated power, 100V, 20Hz - 20kHz) at 8 ohms)> 104dB
THD (full rated power, 20 Hz - 20 kHz)0.35%
Damping Factor (20 Hz to 100 Hz)> 1000
Frequency Response (8, 20 Hz - 20 kHz)+/-0.25dB
Crosstalk (below rated power) 20 Hz to 1 kHz> 80dB
Input Impedance (nominally balanced, nominally unbalanced)20 k balanced, 10 k unbalanced
Dimensions (inches) (W x H x D) (depth not including 1.3 inch front panel protrusion)19 x 3.5 x 14.71
Weight17.2 lbs (7.8 kg)
Power Supply Connector15A IEC connector, 100 , 240V
  • Exclusive multi-patented DriveCore Technology , The patented DriveCore integrated circuit combines hundreds of discrete circuits into one chip for better performance, lower power consumption, and improved reliability
  • BLU link digital audio transport , Up to 256 Channels of digital audio over Category 5e cabling (available on BLU link CDi DriveCore models)
  • Supports configuration and control using HiQnet, Audio Architect
  • Monitoring and control over TCP/IP
  • Color LCD and front panel user interface for amplifier configuration, control, and monitoring
  • Programmable GPIO (general purpose input/output) control port
  • Digital signal processing (Input/output EQ filters, crossover, input/output delay, LevelMAXTM limiters)
  • Support for importing of FIR filter coefficients
  • 20 device presets , 1 factory and 19 user
  • 96kHz/32-bit floating-point signal processing
  • Universal power supply with PFC for reduced current draw and industry-leading efficiency
  • Power saving modes
  • Remote power off , Sleep mode activated via AUX port
  • 70Vrms/100Vrms direct drive
  • Each channel independently configurable for low z or high z operation
  • Advanced protection circuits , Amplifier and loads are protected against shorted outputs, DC, mismatched loads, overheating, over/under-voltage, and high-frequency overload
  • Three years, no-fault transferable warranty , Your investment is fully protected
  • Complies with GreenEdge by HARMAN , Environmentally friendly practices in design, manufacturing, and packaging complement energy-efficient operation
  • Support for BSS Audio, Soundweb Contrio Ethernet wall controllers
  • Included speaker tunings for various JBL, speaker models

£2,332.44
£3,534.00
Earn0
reward points


Oh No! This product is out of stock. Would you like to know when it's avaliable again?